Moon Air provides fast, reliable air conditioning, heating, and electrical services to the residents of Millington, MD and the surrounding areas!

We pride ourselves on a high standard of customer service. Read our reviews and find out why your neighbors consider us to be their preferred HVAC company and electrician in Millington, MD.

Local Reviews
for Millington, MD

Moon Air Inc. Rated 5.0 out of 5 stars based on 1 customer reviews


Map of Millington, MD

Great Service and knowledgable personnel !




Review of Moon Air Inc.

The service rep was fast ,friendly and competent!


Craig D.

Craig D.

club service oil. Air filter looks clean. Changed nozzle and changed oil filter. cleaned cad cell, cleaned oil gun, cleaned electrodes and adjusted them. smoke test came up clear. bled air/oil out of the system. found indoor voltage enhacement system la ying on the bottom of the cabinet, mouted it to prevent short or spark. oil furnace is running properly at this time.

Near Dudley Corner Rd, Millington, MD 21651
Craig D.

Craig D.

Club Service. Successfully ran heat pump through operation. Return temperature 75 degrees, Warm supply temperature 105, Total heat rise 30 degrees. Filter changed provided by customer. Inspected and Tighten all screws, and electrical connections. brushed off control board, cleaned inside and outside cabinet with microfiber towel, and throughout. Inspected blower motor wheel which looks clean, and runs without restriction. Blower motor amps were 5.1. coil looks clean and drain as well, recommened and installed pan treatment to keep it that way. Successfully Test ran outdoor unit defrost cycle. Rla 7.4 Amps, fla 0.6 amps, Outdoor voltage enhancement system read 37.5/5.4 vs factory spec of 35/5., and is within allowable fault. Voltage gateway system is getting 244 volts through it with no voltage drop and shows no pitting on contacts. unit is working properly at this time.

Near Spring Rd, Millington, MD 21651
Clay K.

Clay K.

Unit not running. Checked air handler and found water switch was open. Checked condensate pan and found a crack in the pan to the indoor coil. Caulked for tempory fix. Also checked refrigerant charge and found no problem.

Near Spring Rd, Millington, MD 21651
Craig D.

Craig D.

Found 2 problems with system. Condensate safety system tripped. Intermittent issue with low voltage control system. Checked wiring connections.

Near Big Stone Rd, Millington, MD 21651
Gerald T.

Gerald T.

Two-year-old heat pump. The outdoor ambient temp was approximately 72 degrees and the indoor dry bulb was approximately 76 degrees. The cool supply air was 55 degrees and the room temperature return air was 75 degrees for a Delta T of 20. Measured .8 Amperes and volts on the air circulation system and its voltage enhancer had a correct uF charge. Cleaned the EZ Trap safety sensor and added some descaler to it to prevent clogs. Also purged the pipe with CO2. Verified the circuit board and wiring were in good condition, and the 25 and 60-amp circuit breakers had a normal 245 Volts through them. The air circulation compartment was clean with no black growth developing. The indoor coil and its pan were clean and confirmed the wet switch was working. The refrigerant pumping system's run amps were 4.6 (RLA is 11), the start amps were 4.6, and the air exhaust system's amps were .6 (FLA is .95). Cleaned the electrical compartment, and verified the blades, disconnect, defrost board, wiring, and

Near Spring Rd, Millington, MD 21651
Gerald T.

Gerald T.

Two-year-old heat pump. The outdoor ambient temp was approximately 72 degrees and the indoor dry bulb was approximately 76 degrees. The cool supply air was 55 degrees and the room temperature return air was 75 degrees for a Delta T of 20. Measured .8 Amperes and volts on the air circulation system and its voltage enhancer had a correct uF charge. Cleaned the EZ Trap safety sensor and added some descaler to it to prevent clogs. Also purged the pipe with CO2. Verified the circuit board and wiring were in good condition, and the 25 and 60-amp circuit breakers had a normal 245 Volts through them. The air circulation compartment was clean with no black growth developing. The indoor coil and its pan were clean and confirmed the wet switch was working. The refrigerant pumping system's run amps were 4.6 (RLA is 11), the start amps were 4.6, and the air exhaust system's amps were .6 (FLA is .95). Cleaned the electrical compartment, and verified the blades, disconnect, defrost board, wiring, and

Near Spring Rd, Millington, MD 21651
Gerald T.

Gerald T.

Just made sure another heat pump owner will have a smooth operating unit for this weekend's warmer weather.

Near Kent View Ln, Millington, MD 21651
Gerald T.

Gerald T.

Just made sure another heat pump owner will have a smooth operating unit for this weekend's warmer weather.

Near Kent View Ln, Millington, MD 21651
Gerald T.

Gerald T.

Making sure another customer will have cool air in their house when the warm spring arrives.

Near Dudley Corner Rd, Millington, MD 21651
Gerald T.

Gerald T.

Making sure another customer will have cool air in their house when the warm spring arrives.

Near Dudley Corner Rd, Millington, MD 21651
Sean D.

Sean D.

replaced dual capacitor, contactor and installed hard start kit on Amana heat pump.

Near Fords Landing Ln, Millington, MD 21651
Sean D.

Sean D.

Completed oil tune up on Armstrong oil fired forced air system.

Near 2nd St, Millington, MD 21651
John A.

John A.

Customer getting Club membership AKA service contract to ensure HVAC system stays efficient throughout its life

Near River Rd, Millington, MD 21651
John A.

John A.

Performing a load calculation on a home to ensure proper sizing of HVAC equipment

Near River Rd, Millington, MD 21651
John A.

John A.

Getting a price for a new air conditioner

Near River Rd, Millington, MD 21651
John A.

John A.

Giving a price for a new heater

Near River Rd, Millington, MD 21651
John A.

John A.

Installing energy star rated heating and air conditioning system

Near River Rd, Millington, MD 21651
John A.

John A.

Delmarva rebates on HVAC equipment

Near River Rd, Millington, MD 21651
John A.

John A.

New propane furnace

Near River Rd, Millington, MD 21651
John A.

John A.

Whole house humidifier

Near River Rd, Millington, MD 21651
John A.

John A.

Clean ductwork

Near River Rd, Millington, MD 21651
John A.

John A.

Heater inspection

Near River Rd, Millington, MD 21651
John A.

John A.

Air conditioner tune-up

Near River Rd, Millington, MD 21651
John A.

John A.

Free heat pump estimate

Near River Rd, Millington, MD 21651
John A.

John A.

Free air conditioner estimate

Near River Rd, Millington, MD 21651